Straight panels.

Hi, I have a curved surface and straight panels. Is it possible to curve the panels in the same way as the surface.

Attachments:

Replies to This Discussion

Permalink Reply by Rajaa Issa on February 3, 2014 at 4:56pm

Hi Martin,

Here is what I did to create the image below:

1- Shrink your surface (use ShrinkTrimmedSrf command in Rhino). This way I was able to offset your surface more easily and get a clean offset surface that can use as a bounding surface.

2- Use a polysurface as your module. This way you can deform it when populated on your surface. I used a simple box inside a bigger bounding box to create the spacing.

I also attached the GH file. Let me how that helps.

Attachments:

ribs.gh, 11 KB

Permalink Reply by Alberto Senigagliesi on February 17, 2014 at 4:12am

Hi Rajaa
I have a lot appreciated your explanation;
but I have a question for you :
How did you set up " module bounding Box",
can you post an example ?
Many thanks
best
al

RSS