algorithmic modeling for Rhino

Voronoi on torus, definition:


Vicente showed a more elegant solution, i always seem to forget that we have a 3D voronoi component :) this is the def based on the one Vicente made:

Views: 14008


You need to be a member of Grasshopper to add comments!

Comment by Arie-Willem de Jongh on May 30, 2014 at 3:49pm

Nice job Tobias! Looking cool!

Comment by Tobias Hackbeil on May 28, 2014 at 10:43am

Vincent - thank you very much! I worked with your def - for a jewelery ring. I had printed with our 3D Printer in high quality - very well! I will produce some more pieces - and than we want to cast in silver 925.

Comment by Oliver Hampel on May 27, 2014 at 8:33am


You posted a screen shot of your definition. I am a beginner and learning by deconstructing examples that I find here. I was hoping you could post the grasshopper file so that I may learn from it. I tried to reconsturct your definition form the screen shot but can't quite get it to work.

Thank you,


Comment by Kenny Arnold on May 2, 2014 at 11:52pm

I am trying to figure out how to get this to work and I end up with this. The runtime error i am getting is saying that the topology is invalid. and it suggests that I use Weaverbird's clean up mesh. Anyone run in to this problem I saw Asaf had something similar but no answer was posted..

Any guidance at all would be appreciated.

Comment by Nick Tyrer on May 2, 2014 at 11:32am

well... it came up on front page when you commented...

Comment by Kenny Arnold on May 2, 2014 at 11:22am

Thanks so so much! The thread is alive!

Comment by Nick Tyrer on May 2, 2014 at 11:15am


Danny explains it pretty comprehensively here:

Comment by Kenny Arnold on May 2, 2014 at 11:14am

Hey grasshoppers,

I see that this thread is two years old but i was wondering if perhaps someone could explain to me what is the name of this component is and what does it do?

Comment by Arie-Willem de Jongh on September 10, 2012 at 10:13am

I send you a  mail Asaf hope it helps

Comment by Vicente Soler on September 9, 2012 at 10:39am

can you attach the files?





  • Add Photos
  • View All


  • Add Videos
  • View All

© 2023   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service