surface bridging wb

Comment

Comment by D. Lee on June 12, 2014 at 7:33am

Hey Paco! Very nice definition! :) do you know if its also possible to define the positions of the columns more precisely than to postion them by the sliders?

kind regards

Lee

Comment by Paco Ortiz Vázquez on January 3, 2014 at 4:34pm

Sorry I didn´t meant to post it as my work, i will post the source when I use one, you are right Michael, my bad.

Comment by Michael Pryor on January 3, 2014 at 12:09pm

:))) Well it is meant to be copied. But when you post it as "your" work and then send screenshots of "your" gh instead of the link you copied from. Its like come on......... lol

Comment by Nick Tyrer on January 3, 2014 at 12:05pm

Come on Michael, not only has an extra 'bridge' been added, but he has clearly got rid of those pesky group boxes...

Comment by Michael Pryor on January 3, 2014 at 11:55am

Next time you should site your source, especially when looking at your screenshot you just fully copied it ;)

http://formularch.blogspot.com/2012/05/gh-surface-bridging.html

Comment by Per Petersson on October 23, 2012 at 11:39am

Hi Paco

Sent you a message!

I was in the north of sweden. No computers no cellphone only reindeers on the road!!

Best regards

Per

Comment by Paco Ortiz Vázquez on October 18, 2012 at 12:36pm

sorry man!!! i've been busy, but give me your e-mail and i will send you my definition.

Comment by Per Petersson on October 11, 2012 at 10:24am

ahhh, thanks for that...

But tried it and that did not do the trick, is there something about how I select the surfaces? I use "Set Multiple Surfaces" (reference mode). Because I can switch to either have the upper or the lower surface doing the lofting by selecting the one after the other. But I cant get them to  both loft at the same time though.

So any other ideas? And thanks for keeping up with me, I am a newbie at GH... maybe its obvious.

Best regards

Per

Comment by Paco Ortiz Vázquez on October 10, 2012 at 9:25pm

check the second weave component, the one before the highlighted loft. That one is the problem, you have to switch to GRAFT the "2" in the component.

Comment by Per Petersson on October 10, 2012 at 2:02am

Hi again Paco

I think I got it together, but having problem with the lofts coming from the upper surface and I cant figure out how to make them or find them. Any hints would be very welcome!

Attached is my (our) def and the result I am having at the moment.

• ‹ Previous
• 1
• 2
• Next ›
• Page