Grasshopper

algorithmic modeling for Rhino

Views: 1013

Comment

You need to be a member of Grasshopper to add comments!

Comment by kyle_01 on March 21, 2012 at 10:46am
In your definition, how did you stop the metaball component from making circles at each point along the divided curves? I am getting an overlap of metaball circles where I just want the final outlines at each cross section. I am not quite sure how to use multiple curves with the metaball and get clean cross sections or "floors"
Comment by qsq arc on November 28, 2011 at 3:26am

mesh from points never looks good and it's quite slow

Comment by Michael Pryor on July 21, 2011 at 12:50pm
Didn't read the title first so obviously its metaball lol, ever figure out how to make it a surface?
Comment by Michael Pryor on July 21, 2011 at 12:45pm
Im guessing you used the metaball for this, Atleast thats how i do it, I cant ever figure out how to get a smoothe surface rather than a contoured one, I sometimes try mesh from points, but it never really looks good.
Comment by Reza Eslami on April 1, 2011 at 3:17am

قابلی نداره علیرضا خان. قدیمی اند . جدیداشو آپ میکنم باحال ترند

 

Comment by Ali Who! on April 1, 2011 at 3:09am

watch this video george, i think it'll help:http://www.youtube.com/watch?v=s9bnKpqoxBY

آقا رضا! کارات فــــــــــــــوق العادست

Comment by Reza Eslami on March 25, 2011 at 12:22pm
just a form ;)
Comment by hassan.orion on March 25, 2011 at 12:14pm
good going... is it just the form or u have thought somthing beyong? just curious
Comment by Reza Eslami on March 25, 2011 at 6:53am
yes its done with 100-200s of points along 5-6s curves ...
Comment by GEORGE on March 25, 2011 at 6:45am

really nice, is this done with 100s of points along a curve??? or how you did this???

 

About

Translate

Search

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service