should not be open).
3. All releases of Rhino 5, Arduino, GH, and FF are the latest as of May 21st.
I Boolean toggled the port open, but I can't seem to get any output to display from the UnoRead component. I was hoping to see values from any of the analog inputs (APin5 depicted) connected as info gets sent back and forth between the Arduino and my comp. I'm getting simultaneous "Hooray" and "Whoops" messages, and I can't pinpoint why. See attached JPG.
Does it have to do with the fact that I have a list of COM ports? Even though I know COM 3 is the correct one as defined in the IDE, do I need to re-declare it in Grasshopper as well? Does the {0} shown impact this output?
Any direction is appreciated.
Thanks - JFig
…
the curves on surface issue it's solved seting flatten to the surface control point output. Still didnt know how to group points like:
1;1, 2;2, 3;3.....
1;2, 2;3, 3;4....
1;3, 2;4, 3;5...
....
s to work.
Anyway I only managed to calculate the number of combinations with 5 elements by dropping the results immediately.
1769539000 * 9 * 32 bit = 63.7GB…