know how to solve.
It appears in
11 - Honeybee Energy Modeling - The Laws of Geometry in E+ Part 3: Curved Geometry
where I need to retrieve .idf file,
and shows this message:
1. Solution exception:'hb_EPZoneSurface' object has no attribute 'punchedGeometry'
I've added .gh file at a state where I meet the problem.
Also, I've looked around the forum and found some mention OpeanStudio related problems, mainly one's lack of it. Could it be the source of the problem, because I only followed Installation Instructions and haven't installed OpenStudio.
…
hat cross that one section?
What about the other 54 sections of the large surface?
Three of the ten vectors created from those lines go in opposite directions - so how useful is their average ('Avr')? Maybe that's why...
You want to subdivide ('SubSrf') this one section (of 55 total on the larger surface) and find the line segments (which become vectors) that cross each sub-section?
Is this correct so far?
By the way, in the second part of your code on the right, you are using 'VRot (Rotate a vector)' to rotate a line - that you created from a vector; probably could be simpler?…
etting when I merge the three trees, but what I would like to get is:
essentially a tree with 27 branches, each with a single list of either 11 or 21 points.
{0} (N=11)
{1} (N=11)
...
{10} (N=21)
{11} (N=21)
...
{17} (N=11)
{18) (N=11)
{27} (N=11)
Any help would be greatly appreciated.
All the best,
Matt
…
Added by Matt Schmid at 3:06pm on December 4, 2010
9 8 7 6
5 4 3 2 1 0
I am triangulating this surface. I want to select just the red vertices. As you can note, I just need the inner vertices of this surface. I could do it mannually, but if I want to change the mesh density later, I will have to pick all of them manually again later.
Can someone help me?
Tks
…