EC
1. Between hours 1:00 to 24:002. Current document units is in Meters3. Conversion to Meters will be applied = 1.0004. [1 of 7] Writing simulation parameters...5. [2 of 6] No context surfaces...6. [3 of 6] Writing geometry...7. [4 of 6] Writing materials and constructions...8. [5 of 7] Writing schedules...9. [6 of 7] Writing loads and ideal air system...10. [7 of 7] Writing outputs...11. ...... idf file is successfully written to : c:\ladybug\Freeformtower_IDF\EnergyPlus\Freeformtower_IDF.idf12. 13. Analysis is running!...14. ......
Done! Read below for errors and warnings:
15. 16. Program Version,EnergyPlus-Windows-64 8.1.0.009, YMD=2015.04.04 23:39,IDD_Version 8.1.0.00917. 18. ************* IDF Context for following error/warning message:19. 20. ************* Note -- lines truncated at 300 characters, if necessary...21. 22. ************* 577 Zone,23. 24. ************* Only last 1 lines before error line shown.....25. 26. ************* 578 Freeformbuilding27. 28. ** Warning ** IP: IDF line~578 Comma being inserted after:" Freeformbuilding" in Object=ZONE29. 30. ** Severe ** Out of range value Numeric Field#5 (Type), value=0.00000, range={>=1 and <=1}, in ZONE=FREEFORMBUILDING31. 32. ************* IDF Context for following error/warning message:33. 34. ************* Note -- lines truncated at 300 characters, if necessary...35. 36. ************* 586 BuildingSurface:Detailed,7341.
…
5 8, and then the following values are obtain as the last one (8) plus 3, then this last one (11) plus 5, and then this last one (16) plus 8, and then it starts again: 24+3, 27+5, 32+8...
Thanks
…
Added by Jesus Galvez at 5:17am on November 27, 2012
u; IL 24, Lightweight Principle
Dtsch.-Engl.. (Form, Kraft, Masse 4; Mitteilungen des Instituts für leichte Flächentragwerke der Universität Stuttgart)
Frieder Klenk
Hrsg.: Univ. Stuttgart, Institut für Leichte Flächentragwerke -IL-;
1998, 288 S. m. zahlr. Abb., 2 Beil. 21 x 27 cm, Kartoniert/Broschiert
Sprache: Englisch
ISBN 978-3-7828-2024-0 | Krämer, Stuttgart…
problem is that I am inputting 8 points and getting 24 point out because grasshopper is matching every point to every surface. The correct way would be 3 points for surface {0}, 3 points for surface {1}, and 2 points for surface {2}.
Anyway, is there a way to say that every branch with a {0;?} should relate to the {0} surface, the {1;?} branches should match with the {1} surface, etc?
…
I have a tree that has 25 branches and each branch has 4 values
{0;0;0} (N=4) ....{0;0;24}(N=4)
is there a way to compile a list of the min value of each branch? ie the list should contain 25 numbers.
Added by jon kontuly at 3:51pm on January 24, 2010