mull&Clark.
You have to specify
the minimum height of a plane (-1 here)
The number of subdivision in X and Y (100 x 100)
the subdivision for CatmulClark (smooth the surface if 1, 2 or 3 an also augment the number of facets)
Antother with 5 760 000 facets, but too much discredization so it didn't smooth the Delaunay mesh.
…
the problem with 25 sliders (3 possible positions each), galapagos send me an error when it's running for long time.
I've uploaded a screenshot with the error. Galapagos and Ecotect run and calculate 100 values and then the errors appear ( I guees that 100 values are 50pop*boost).
Using old Galapagos, Geco and Grasshopper there is no problem at all running definition.
Galapagos conf:
Using evolutionary solver.
Max.Stagnant: 40
Population: 50.
Boost: x2
Manintain: 5%
Inbreeding: 75%
25 sliders with 3 possible values: 0.01, 0.09, 0.018
Best Regards.
Ángel.…
Added by Ángel Linares at 11:50am on September 6, 2011
I have literally read 100 versions on how to do this and I still can't do it.
Can someone point me towards how to do it on version 0.9.0061 and Rhino 5
poly%20tunnel.gh
Thanks
Added by STANLEY JONES at 12:28pm on October 15, 2013
two icons run the same script. They both read as "ForceDirectedDrawing". I believe that the top one should activate the "DiskoGraphDrawing" command. Is this correct and is it just that Syntax is not completely compatible with GH6?
Thank you Chris D.…
eate a surface from any where between 3 sides and 100 sides depending on the outline and the outline will always be drawn by a polyline.
Any guidance would be appreciated,
Thanks,
Zach…
over time) between each count. Otherwise this script would essentially be the same as the Firefly counter.
Actually looking at your code again, is "counter Mod 5 = 0" referring to a variable modulus? I guess that could sort of be used to create variable delays (when the modulus = 5, the timer will only fire every 5 intervals (which would be constant in this case e.g. 100 ms or something).
I'll think more on it... Davids words seem encouraging though, so I think I'm going to start off on that route.…
Added by Brian Harms at 10:21am on January 20, 2012
100 "check points".
'Manual' or 'Test All' (green group) - 'Test All' generates a series of 90 curves with 10 to 100 control points and finds the lowest count who's 'Max Difference' is less than or equal to the 'Tolerance' slider value.
…
Added by Joseph Oster at 9:20am on August 20, 2016
of the left mouse button!)
3) Scroll the mouse wheel to zoom in on the target object
4) Connect the wire.
--
David Rutten
david@mcneel.com
Poprad, Slovakia…
Added by David Rutten at 3:26pm on October 13, 2010