ggle A
7. Toggle A
8. Toggle 2
9. Toggle 3
10. Toggle A
11. Toggle A
12. Toggle 3
I was thinking to use somehow slider and animate option....but without luck
Any idea would be appreciated…
ve a Vertex [V] connected to four other Vertexs [N1-N4].
Each of the has a Value:
V ... 1
N1 ... 5
N2 ... 3
N3 ... 8
N4 ... 11
The Average Filter would set the Value of [V] to
(1+5+3+8+11)/5 = 5,6
The Median Filter would Sort Values and pick the middle one
1,3, [5], 8, 11
Hope that helped...…
fault materials...6 RAD materials are loaded1. 2. Downloading OpenStudioMasterTemplate.idf to c:\ladybug\3. Loading EP construction library4. 206 material found in c:\ladybug\OpenStudioMasterTemplate.idf5. 30 windowmaterial found in c:\ladybug\OpenStudioMasterTemplate.idf6. 284 construction found in c:\ladybug\OpenStudioMasterTemplate.idf7. Loading EP schedules...8. The ScheduleTypeLimits: Fraction is already existed in the libaray.You need to rename this ScheduleTypeLimits.9. The ScheduleTypeLimits: Temperature 7 is already existed in the libaray.You need to rename this ScheduleTypeLimits.10. 21 scheduletypelimits found in c:\ladybug\OpenStudioMasterTemplate.idf11. 1370 schedule found in c:\ladybug\OpenStudioMasterTemplate.idf12. 13. 14. Hooohooho...Flying!!Vviiiiiiizzz...…
know how to solve.
It appears in
11 - Honeybee Energy Modeling - The Laws of Geometry in E+ Part 3: Curved Geometry
where I need to retrieve .idf file,
and shows this message:
1. Solution exception:'hb_EPZoneSurface' object has no attribute 'punchedGeometry'
I've added .gh file at a state where I meet the problem.
Also, I've looked around the forum and found some mention OpeanStudio related problems, mainly one's lack of it. Could it be the source of the problem, because I only followed Installation Instructions and haven't installed OpenStudio.
…
g a nurbs curve through a set of N-dimensional points is not the same as cubic interpolation of a linear data-set.
It's certainly possible to fit a nurbs curve through a set of point with a one-x-one-y constraint, but Rhino does not have such a fitter in the SDK, so it needs to be written from scratch.
--
David Rutten
david@mcneel.com
Poprad, Slovakia…
etting when I merge the three trees, but what I would like to get is:
essentially a tree with 27 branches, each with a single list of either 11 or 21 points.
{0} (N=11)
{1} (N=11)
...
{10} (N=21)
{11} (N=21)
...
{17} (N=11)
{18) (N=11)
{27} (N=11)
Any help would be greatly appreciated.
All the best,
Matt
…
Added by Matt Schmid at 3:06pm on December 4, 2010