otate 9°, the second module 18°, the third 27°, etc. I can only seem to get all 11 modules to rotate the same... I know it probably has something to do with series but I can't figure it out. the screen shot shows the 11 modules rotating to the same degree and the drawing is a plan of what I am trying to accomplish. Thank you so much in advance!…
Added by Daniel Lamm at 6:54pm on September 4, 2014
ee 3)
{5}
0 15
{6}
0 16
And I want to place points at every possible combination of these coordinates, treating Tree 1 as X coordinates, Tree 2 as Y coordinates, and Tree 3 as Z coordinates. Also, I would like the list of points to be a tree with paths corresponding to the coordinates. Wouldn't it be nice if I could plug these trees into a Point XYZ, with a new "branch cross reference" method, and get the following result?
{0:3:5}
0 {10.0, 13.0, 15.0}
{0:3:6}
0 {10.0, 13.0, 16.0}
{0:4:5}
0 {10.0, 14.0, 15.0}
{0:4:6}
0 {10.0, 14.0, 16.0}
{1:3:5}
0 {11.0, 13.0, 15.0}
{1:3:6}
0 {11.0, 13.0, 16.0}
{1:4:5}
0 {11.0, 14.0, 15.0}
{1:4:6}
0 {11.0, 14.0, 16.0}
{2:3:5}
0 {12.0, 13.0, 15.0}
{2:3:6}
0 {12.0, 13.0, 16.0}
{2:4:5}
0 {12.0, 14.0, 15.0}
{2:4:6}
0 {12.0, 14.0, 16.0}
In this form of cross referencing, every combination of individual branches from the different lists is used as separate input, and the output for each combination is put onto a branch in the result whose path is the concatenation of the input branch paths used.…
Added by Andy Edwards at 7:03pm on November 3, 2009
segments (ie. polylines)
2 = conic section (ie. arcs, circles, ellipses, parabolas, hyperbolas)
3 = standard freeform curve
5 = smoother freeform curve
The higher the degree, the less effect a single control-point has on the curve, but the further that weak effect reaches. Degree=5 curves are smoother, but it's also harder to add local details to it without adding a lot of control points. Rhino supports curves up to degree=11, but you almost never need more than 5.…
h true false pattern.
I graft the path list so i get a new path for each path item instead of a flat list. (50 paths, one path name each)
I pass that list into a tree item component.
Despite using cross reference, i only get the first item.
I should be getting 50 items in 50 paths.
Does anyone know what could be going on?…
Added by kermin chok at 5:08pm on December 4, 2009