est of the best)
Crucial DDR4 2133 ECC (what else?)
4* WD RE 500 in Raid combo (not shown)
Some stupid 2.5'' HD thingy (avoid 2.5'' disks)
No SSD thingy
Corsair CPU cooler (Tequila replaced the OEM liquid: it works)
…
ase to give the same result using a graph mapper with a parabola as in the attached file
Unfortunately it never gave the same result ..... is it a mistake in the book ?!…
moved by random amounts in a random direction. The animated slider was the amount of deviation from the original points. And yes, I used culled lists.B.t.w. did you find my workaround for your loft? Did your notebook explode? ;)…
a working solution with replacing this line of code with:
Dim charList As New List(Of Char)(charArr)
Is this because of a version incompatibility (I'm using Rhino 4.0, and GH 0.8.0062)? Just curious.
Regards,
JJ…
, a1200)}) Is there any way I can make this list into {a1, a2, a3, a4, -a5, -a6, -a7, -a8, a9, a10, a11, a12, -a13, ..... , a1200} ? ( 4 positive signs then 4 negative signs and so on) - alternating every nth in general.
or
2. Is there any way (workaround) to get negative angle value from 2 vectors? I know 'ANGLE (of 2 vectors)' component by itself doesn't work and I know why too. I have feeling that the reflex angle output might be useful but again, matter of list manipulation.
Any help would be greatly appreciated. Thanks in advance.
Hyo
…
f the mesh was self-intersecting everywhere. So instead I used Millipede (isosurface) to get the same undulations, but ignore the complex 'folds', you can see the difference in cross section thickness. I then tessellated it with the inverse pattern of the outer surface.
To make it a single 3d printable mesh, i just deleted a single face on inner and outer skin, then lofted the naked edges. (creating a tiny hole through the model). Therefore creating a single mesh that folds in on itself, not sure if there is a better way of defining the space between two meshes as the solid area...
Full GH (Kangaroo - Meshmachine - Weaverbird - Millipede)
Special thanks to Laurent Delrieu for his interesting offset mesh method that i based my approach on.
http://www.grasshopper3d.com/forum/topics/offset-mesh-problems-with-3d-mesh-with-weaverbird…
Added by Nick Tyrer at 5:25am on December 10, 2015