should not be open).
3. All releases of Rhino 5, Arduino, GH, and FF are the latest as of May 21st.
I Boolean toggled the port open, but I can't seem to get any output to display from the UnoRead component. I was hoping to see values from any of the analog inputs (APin5 depicted) connected as info gets sent back and forth between the Arduino and my comp. I'm getting simultaneous "Hooray" and "Whoops" messages, and I can't pinpoint why. See attached JPG.
Does it have to do with the fact that I have a list of COM ports? Even though I know COM 3 is the correct one as defined in the IDE, do I need to re-declare it in Grasshopper as well? Does the {0} shown impact this output?
Any direction is appreciated.
Thanks - JFig
…
53 → 53 → 63 → 74 → 74 → 84 → 9
As you can see from the above list the connection sequence comes in waves of three, where each group of similar indices on the left is associated with a group of three incrementing indices on the right.
Some combination of Series components will probably generate this list, but it'll only work for the first ring, the second one will need a different connection pattern. It is perhaps better to just encode the integer pairs by hand. But then you cannot change your mind about the number of sides later.…
Added by David Rutten at 10:39am on October 21, 2015
s {0} with 0/1/2 and the values 1/1/1
{1} with 0/1/2 and the values 2/2/2
{2} with 0/1/2 and the values 3/3/3
Second data set contains 3 items {0} with 0/1/2 and the values A/A/A
{1} with 0/1/2 and the values B/B/B
{2} with 0/1/2 and the values C/C/C
After merging the 2 data sets i need as result one data set with 6 items {0} with 0/1/2 and the values 1/1/1
{1} with 0/1/2 and the values 2/2/2
{2} with 0/1/2 and the values 3/3/3
{3} with 0/1/2 and the values A/A/A
{4} with 0/1/2 and the values B/B/B
{5} with 0/1/2 and the values C/C/C
How can i realise this?…
That is correct. In reality there are 3 major versions of .NET 1, 2, and 4 (different versions of mscorlib.dll)
Rhino 4 uses .NET 2 which includes 3 and 3.5.
Rhino 5 uses .NET 4
know how to solve.
It appears in
11 - Honeybee Energy Modeling - The Laws of Geometry in E+ Part 3: Curved Geometry
where I need to retrieve .idf file,
and shows this message:
1. Solution exception:'hb_EPZoneSurface' object has no attribute 'punchedGeometry'
I've added .gh file at a state where I meet the problem.
Also, I've looked around the forum and found some mention OpeanStudio related problems, mainly one's lack of it. Could it be the source of the problem, because I only followed Installation Instructions and haven't installed OpenStudio.
…