Hi, I love this work... I just started using Kangaroo, but a bit lost. Did you achieve this by adding PLaw as the force? I keep getting an error message saying index is out of range.

Will you be able to give me some insight into this?

Thanks in advance!

Be carefull about the position of anchor points, it must be over a point in the mesh and then you must click on reset. I've only used the examples from Daniel Picker and modified it to fit the model i would like to have (new components to control deformation, units tweeck, some control geometry to generate the mesh using pedestrian paths and other stuff, etc.)...

Thanks! I will keep it in mind!