Crystallon

59 members

Description

Crystallon is an open source project for creating lattice structures using Rhino and Grasshopper3D. The goal is to generate lattice structures within Rhino’s design environment without exporting to 3rd party software, with the advantage of modularity and the ability to combine other powerful tools available for Grasshopper3D. Each tool is left as a cluster which can be opened and modified at will, in the spirit of open source. We hope the community will continue to develop and contribute through the use of the Grasshopper forums and Github. 
 
 
 
Comments Discussions Members

Morphing Between Meshes After Divide Surface

by Dominique Escandon

Oct 22, 2021

I have constructed two flat surfaces which I would like divide differently (same number of sections, but one with parameters established using a Bezier curve and the other evenly divided). I'm using the divide surface tool to obtain a quad mesh, but once I put it through the "Morph Between Meshes" tool, it fails to construct voxels.  It does create this weird geometry outside of the two surfaces however (pictured, it's the green lines outside the surfaces).

As a test, I ran it through the "Morph between Surfaces" tool, and it works just fine. (Also pictured, it's the red structure between the surfaces) However, I really want non-linear divisions in Y on one surface only. 

Really not sure what the problem is and I'd appreciate any help!

Rhino + Grasshopper files attached. Thank you!

  • up

    Alexis Andreou

    Good afternoon, try to change the "Number slider" to "Range" (0-1) as per screenshot

    Hope this helps)

    1

    Oct 23, 2021