Curv Rebuild Problem

by Stephan Schmidt

Jun 19, 2013

Hey everybody,

i have a problem with mapped curves. when i ordinary map the curves to a bent surface the result isn´t in the right position. the curvature isn´t similar(left pic). So i

rebuild the curvs and i get a better curvature but then they are these shaky things(right pic).

Can someone tell me why? Please!!

thx for comments.

  • up

    Caelum Praecelsus Arquitectura

    I have had this problem lately as well when pulling or projecting curves, and have found that even when using the rebuild component the issue you are describing with the shaky lines still exists. My workaround while not the most efficient has been to use the divide curve component and put as many divisions as needed to make an interpolated or basic curve through those points that matches the original - and you will get a smooth curve again.

    2

    Jun 19, 2013

    • up

      Stephan Schmidt

      I've tried both

      Jun 20, 2013