Grasshopper
Taper Pipe Command??
I've been musing over this for a while...
Is there an efficient way of piping the outer poles of my model so that the bottom diameter is larger and each tapers towards a smaller diameter at the top?
This is a standard function in Rhino, but the pipe command in GH doesn't allow for this in the same way, and i can't seem to find an 'easy' work-around in GH.
It may come to me in my sleep, but any ideas are more than welcome!
Thanks,
Is there an efficient way of piping the outer poles of my model so that the bottom diameter is larger and each tapers towards a smaller diameter at the top?
This is a standard function in Rhino, but the pipe command in GH doesn't allow for this in the same way, and i can't seem to find an 'easy' work-around in GH.
It may come to me in my sleep, but any ideas are more than welcome!
Thanks,
Yann
Why don't you create perpendicular frames all along your curves. use them to localise circles with a radius generated with a serie component, and then loft generated circles?
Jan 11, 2010