How to remove overlapping lines in grasshopper?

by Mikko Leppänen

Oct 31, 2017

When I "bake" curves generated with different kinds of grids, sometimes depending on grid density or structure, result of baking causes lines to overlap.

Is there possible to remove or unify overlapping lines with grasshopper?

This needs to be done for laser cutting, so laser wont cut same area several times etc.


Load Previous Replies
  • up

    Joseph Oster

    When I replied earlier, I didn't see the image you posted.  Had I seen that, and realized how simple your example is - or had you posted code initially - I would have replied as follows:

    10

    Oct 31, 2017

    Load Previous Replies
    • up

      ShynnSup

      You could bake and then "make2d" in rhino.
      1

      Oct 31, 2017

      • up

        Joseph Oster

        This is fun to watch.  A simulation of the cutting tool tracing through each tool path.  'step size' slider controls speed.

        5

        Nov 1, 2017

        Load Previous Replies