Hi! I´ve been trying to figure out how to create a circular pattern similar to the one used on the Nest smoke detector:
I´m trying to create a similar pattern on a 3d object I made (below). I can't figure out a way to conform the circular cut pattern within the boundaries of the surface marked in yellow. I was only able to create a cut pattern using the outer edge as an attractor curve, but still, it was based off an UxV grid, so the holes didn´t conform nicely near the rounded edges or the extruded pipe in corner...
If anybody can shine a light in the right direction for me, I would be very gratefull!
Thanks!
Laurent DELRIEU
Hello,
I tested it with a log spiral, but holes are indeed on an arc of circle.
Jan 11, 2017
mark zirinsky
To my eye, it appears that the next pattern is using discrete hole sizes, made by, for example, 4 or 5 different drill sizes. So, if you takes Laurent's results, take that series of holes, then assign these to 4 or 5 ranges of hole sizes, then that might be closer to the next pattern. Foe example, all holes 0.090 to 0.110 diameter get made by a 0.110 drill, 0.111-0.142 get made by a 0.125 drill, and so on.
Jan 11, 2017