Multiple circle loft problem

by Ben Silverman

Dec 7, 2010

Hello,

I have three circles that I am trying to loft together. However it seems that the circle "start" and "end" are not aligned or something like that because the loft comes out twisted/inverted. Any ideas?

Thanks,

Ben
Load Previous Replies
  • up

    David Wood

    Or use a flip component, one of your curves is pointing in the opposite direction...

    Dec 7, 2010

    • up

      Ben Silverman

      Andrew, I've tried the align sections option. When I toggle it on and off, it just changes where the surface inversion is from between the 1st and 2nd circle to between the 2nd and 3rd circle.

      David, I am trying to get the flip to work, but so far it is giving me the same surface. I'll try to play around with the guide curve to see if I can get it right.

      Thanks.

      Dec 7, 2010

      • up

        I Mike

        the same issue , loft ( already align section curve) only creates the lower part , and sweep 1 doesn't work , is this the bug itself?

        2

        Mar 28, 2016