Sorting Points based on Position

by L]G

Mar 22, 2011

Hi everyone,

 

Im trying to get some point sorted so i can then sort them and link them by polylines, to create a foldable surface. i am really stuck and i can figure out how to get the numbers to start at one of the end point and continue in sequence.

 

Here are some photos of what im trying to say

 

Thanks for Your Help

Load Previous Comments

  • L]G

    Hi Danny, the 'sort points' component is the one i tried to use in the first place. i was looking for a way of sorting the points that i get the diamond shaped surface that could create a self-supporting ceiling.

     

    thanks a lot for your help

    Mar 23, 2011

  • Danny Boyes

    Did you see this Post from David in the thread about 2d sorting? http://www.grasshopper3d.com/forum/topics/sort-mesh?commentId=29852...

    Mar 23, 2011

  • L]G

    Hi Danny, yes, im trying to read it and understand it right now, thanks

    Mar 23, 2011