Ladybug Tools Discussions (2,074)

Sort by:

Discussions	Replies	Latest Activity
Building design with Solar Envelope Hi everybody! I have to design an entire neighborhood, that must addresses the principles of outdoor and indoor comfort and also of sustain… Started by Leonardo Roli	6	Jul 2, 2017 Reply by SIDDHARTHA KODURU
SunPath Hi everyone, Since a few days I have searched solution for my project and I couldn't find, so I hope you will be able to help me. I have to… Started by Łukasz Dwulit	4	Jul 2, 2017 Reply by Łukasz Dwulit
real No Description Started by sherly	0	Jul 2, 2017
Having trouble properly setting the heating/cooling set point schedules Hello, I'm trying to enter custom set point schedules so that my building is only conditioned during occupied hours. After combing through… Started by Priya Gandhi	1	Jul 2, 2017 Reply by Priya Gandhi
run daylight analysis for 8 hours Hi all, I am using automated blinds in my simulation and I can get the daylight analysis for a specific hour in a day. I tried to get Dayli… Started by Ahmad Eltaweel	2	Jul 1, 2017 Reply by sahba samadi
Air walls getting erroneously assigned to internal ceilings? Hello All, back again with what I hope is a simple question, but I have not been able to find a similar thread in this forum. I am trying t… Started by Priya Gandhi	3	Jun 30, 2017 Reply by Priya Gandhi
Issue regarding interior wall, windows, and air wall. Good afternoon I've just started learning ladybug and honey bee. I've successfully did some small simulations with fewer zones and fewer th… Started by Considering	2	Jun 30, 2017 Reply by Considering
Energy Simulation - Differentiate Fixed and Openable Windows Hi Chris, hi all, first of all thank you for the continuous development of Ladybug and Honeybee tools, they are great! I'm working on the e… Started by Andrea Rossi	0	Jun 30, 2017
Radiation Analysis Issue grasshopper.jpgHello, I have the same issue as perscribed above (producing script, downloading EPW file, toggling useoldres." But the resu… Started by Ryan	8	Jun 30, 2017 Reply by Grasshope
Glazing by Ratio on curved geometry -- error: attempted to divide by zero This is weird. Chris' Tutorial showed that it was possible to automate glazing even for curved geometry. I'm planning on automating the cr… Started by Pin	13	Jun 28, 2017 Reply by Frank Gergaud