Karamba3D Discussions (750)

Sort by:

Discussions	Replies	Latest Activity
Element utilization Hello Karamba users, I have a question regarding utilization of elements. Is it possible to make a beam that only utilizes push? The eleme… Started by RaphaelKilsdonk	6	Nov 22, 2017 Reply by Karamba3D
Different cross sections Hi all, I am currently trying to assign different cross section to my model but it seems that i have some problem when i "assemble" my mode… Started by Davide Rando	1	Nov 21, 2017 Reply by Karamba3D
Stress value display on nodes Hi all, I want to display stress values of shell "cross section" structure on nodes. Because the only color display cannot be accepted to… Started by Jaeman PARK	7	Nov 7, 2017 Reply by Karamba3D
Orientation of shell elements Hi,I was wondering if there is a simple way to orient shell elements in a curved mesh (see attached Figure). The only way I found was with… Started by Matej Opacic	1	Nov 6, 2017 Reply by Karamba3D
Adding colour to Karamba model Hi, I am currently testing loads on a series of trusses with Karamba and the deformed model seems to be behaving correctly when I apply a… Started by Rebecca Cooper	3	Nov 6, 2017 Reply by Karamba3D
Member forces due to a load on deck Hi all, I am currently trying to develop a Grasshopper-Karamba model and analysis for getting the member forces in beam or truss due to th… Started by Earth	1	Nov 6, 2017 Reply by Karamba3D
BUCKLING and SPECTRAL ANALYSIS Hi, Im working on a steel gridshell for my thesis and i wonder if i can add a spectral analysis after done the natural vibration analysis.… Started by Giuseppe C	1	Nov 6, 2017 Reply by Karamba3D
Karamba3d - US HSS Sections - SI to Imperial Unit Conversion I have concerns regarding unit conversion between SI and Imperial. Of particular concern is the use of HSS cross sections. The table provid… Started by Maurice Sambora	1	Nov 6, 2017 Reply by Karamba3D
Non-linear Material? Hi, I haven't found it, but maybe it's there: is there a possibility to consider non-linear material behaviour, e.g. plasticity? Best reg… Started by Stefan	7	Oct 30, 2017 Reply by Karamba3D
UPE, C- and L-shaped profiles. I found forum threads from some years back that Karamba did not support the use of UPE (and other C-shaped profiles) or L-shaped profiles.… Started by Timo Harboe Nielsen	1	Oct 25, 2017 Reply by Karamba3D