Karamba3D Discussions (750)

Sort by:

Discussions	Replies	Latest Activity
Mass per element Hi all, I'm working on assessing the sustainability of structural elements. I need the mass per element used (each group of elements can ha… Started by Niels Hofstee	4	Mar 2, 2018 Reply by Niels Hofstee
Master of Science Thesis: Algorithm-Aided Structural Engineering of Steel-Framed Warehouse I made a Master of Science Thesis about Karamba. The main aims of the thesis are to examine the possibilities of algorithm-aided structural… Started by Jukka	3	Mar 1, 2018 Reply by Jukka
LICENSE Hi, I'm having problems with the Karamba license I have formatted the computer and when I go to put the license back, the attached image ap… Started by domenico gaudioso	1	Mar 1, 2018 Reply by Karamba3D
Parametric frame in karamba does not deflect properly I made a frame that is loaded horizontally. But two thing are going wrong. First the points of supports and the points where the horizontal… Started by Rayaan Ajouz	1	Feb 27, 2018 Reply by Matthew Tam
Meshing problems using the Mesh Breps component Hello all, I'm very, very new to Karamba, so please forgive me if these are stupid/common questions. I tried googling but for some reason I… Started by Claire	1	Feb 27, 2018 Reply by John Harding
Shell - Optimize Cross Section This question pertains to shell elements and how to properly use the mesh and optimize cross section features of Karamba. Currently, all o… Started by Maurice Sambora	1	Feb 21, 2018 Reply by Karamba3D
Cross Section Optimiser and SLS Hiya, I'm trying to implement a solution that would stop the optimiser from selecting sections that exceed the SLS.. If I understand corre… Started by nicebikemate	2	Feb 21, 2018 Reply by Karamba3D
Optimize Cross Section - MaxDisp Can you comment on the method in which the Optimize Cross Section function addresses a MaxDisp target? I am working with concrete shell ele… Started by Maurice Sambora	3	Feb 21, 2018 Reply by Karamba3D
Install both 32-bit and 64-bit for Rhino5? I couldn't find an answer to this. I have both Rhino5 32-bit and 64-bit installed. Is it possible to install Karamba3d for both versions? R… Started by Diederik Veenendaal	2	Feb 21, 2018 Reply by Diederik Veenendaal
Mesh load on part of a mesh Hi Karamba users, I have a question regarding mesh loads. I want to put a load on a certain part of a mesh, see the picture below: I now… Started by RaphaelKilsdonk	5	Feb 21, 2018 Reply by nicebikemate