Kangaroo Discussions (1,004)

Sort by:

Discussions	Replies	Latest Activity
Kangaroo Mirror Force Issue Hello, I am currently working with auxetic materials, and I am attempting to simulate a a singular cube shrinking from its original form t… Started by Daniel Vrana	1	Apr 1, 2014 Reply by Daniel Piker
install problem hello, everyone. I'm a beginner in kangroo found some install problems... I did these two steps according to the instruction in the kang… Started by jocelyn	1	Mar 29, 2014 Reply by jocelyn
making this little paper origami model with kangaroo Hello, I'm new to Kangaroo and have been searching for other examples of origami definitions and have been experimenting with the ones from… Started by Adam Roark	0	Mar 23, 2014
remove duplicate lines trouble Hi I am facing the same problem than Nick Tyrer concerning "remove duplicate lines" component. config: rhino 5 SR8 ; Gh 0.9.0072 ; Kangaroo… Started by Minh	1	Mar 21, 2014 Reply by Daniel Piker
Canopy rationalization Daniel, I have a geometry problem that I'm hoping Kangaroo can help me solve but I can't quite get the results I'm looking for. I'm workin… Started by Nate Holland	0	Mar 19, 2014
Shell bending Shell bending from Daniel Piker on Vimeo. Hey everyone, I m new in Kangaroo. I am wondering how can I have a triangulated mesh like thi… Started by jnm	2	Mar 18, 2014 Reply by jnm
Arraying a kangaroo loop along a curve hi, I am trying array a bent curve loop I did in Kangaroo along a curve. It is easy with the non-kangaroo approximation, but not sure how… Started by matei denes	0	Mar 13, 2014
Applying forces to multiple meshes at one go Hey all, I am trying to apply the same force to multiple meshes all using one kangaroo component. It works when I apply it to a single mes… Started by Zhou Joel Wong	4	Mar 12, 2014 Reply by dcjxb
kaleidocycle I attempt to design a kinematic kaleidocycle structure. There is a discussion before about that: http://www.grasshopper3d.com/forum/topic… Started by Jon	2	Mar 11, 2014 Reply by Jon
BendAngle rest angle input Daniel, I was using the bend angle component and noticed that the rest angle input is slightly off. It seems as though the actual rest a… Started by Moonbeast	1	Mar 11, 2014 Reply by Daniel Piker