algorithmic modeling for Rhino
Been googling on this for a bit to find that most packing problems are concerned with getting as many circles as possible into given shapes.
I'd like to do the reverse and pack triangles (polygons) into a circle. I need:
- the edges to be the same lengths as much as possible
- a symmetry, either axial or radial (latter preferred)
I need to be able to set circle diameter and edge lengths with sliders.
I'm using Daniel's MeshMachine and tend to get results like these:
The bottom one has some symmetry I suppose, but what I want is more like this, the only positive result I have managed to achieve:
I struggle to make Kangaroo help me produce several possible solutions to choose from.
How would you do it?
Tags:
the file
Many thanks.
Results tend to be extremly hexagonal looking. To remedy, I've been trying to do this not on a disc but on a fifth or third pizza slice, and then array polarly. Not too successful.
Do I HAVE to use anchor points? Why can't I just tell Kangaroo to use only the circle to pull to, and increase faces dynamically depending on the edge length slider I give it?
It's not clear what you're trying to accomplish. It sounds like you are looking for a periodic tiling that can be perfectly inscribe in a circle? Mathematically I don't think this is possible with a single triangular tiling.
See Euclidean tilings of convex regular polygons.
You can create a repeating pattern and test for inclusion within a region...
Here's some more of my own attempts that I hope will make clear what I'm after.
All of these have a 'hole' in the middle which I don't want, and the edge lengths are too different.
You can also see the anchor points I had to give. Using just a boundary curve doesn't work and the mesh is sucked up immediately. Why is that?
Ideally, I would not want to use anchor points. I want Kangaroo to choose their position and number for me. How?
© 2019 Created by Scott Davidson. Powered by