algorithmic modeling for Rhino
through a series of analogue experiments i have been applying several patterns to plywood to explore the deformation of the material to create a potential sculpture or pavilion. the cuts are to allow for bending and openings to occur.i have attached a photo of one of my models.
i am now trying to record this digitally, to allow me test several patterns and to compare how each pattern affects the surface. the long term goal is to go into Curvature analysis and Galapagos to develop the right cut for the appropriate folding.
any suggestions would be amazing as to how to go about achieving this.
ps. i can upload my patterns if needed
Joe, I´m busy wtih bend and pavilion and I try do with 2 lines: one is a cable and the other is for bending.
I started small for understand how it works... I´ll send my scripts OK?
It is hard to find where you must put your anchor points, i´ve some results with a point and fixing the lines point in it.
I made 2 circles and I made some lines conecting thease circles, and in the end of the lines I start to fix the anchor points...
But I think I fixed to much and the bend doesnt work good...