algorithmic modeling for Rhino
sheet bending and curvature analysis
Hi everyone,
through a series of analogue experiments i have been applying several patterns to plywood to explore the deformation of the material to create a potential sculpture or pavilion. the cuts are to allow for bending and openings to occur.i have attached a photo of one of my models.
i am now trying to record this digitally, to allow me test several patterns and to compare how each pattern affects the surface. the long term goal is to go into Curvature analysis and Galapagos to develop the right cut for the appropriate folding.
any suggestions would be amazing as to how to go about achieving this.
joe
ps. i can upload my patterns if needed
Views: 1510
Replies to This Discussion
-
Permalink Reply by Arthur Lara on
-
Joe, I´m busy wtih bend and pavilion and I try do with 2 lines: one is a cable and the other is for bending.
I started small for understand how it works... I´ll send my scripts OK?
Thanx
Art
- Attachments:
-
-
-
Joe,
It is hard to find where you must put your anchor points, i´ve some results with a point and fixing the lines point in it.
I made 2 circles and I made some lines conecting thease circles, and in the end of the lines I start to fix the anchor points...
But I think I fixed to much and the bend doesnt work good...
:(
Try it!
- Attachments:
-
-
bend02.gh, 18 KB
-
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Twisted Groove
Added by Parametric House 0 Comments 0 Likes
-
Field Dendro
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
