Replies to This Discussion

Permalink Reply by Victor Leung on September 29, 2011 at 12:55am

Hi all,

 

I have similar problems before, I realized that it may be the simulation engine limitation:

Please correct me if I'm wrong.

 

1. The Forces input must be Flattened.

2. All points bust be somehow interacting with each other, either a spring or something.

2.1 This mean there is only one system and one object.

2.2 This means there should not be any points flying freely.

3. The Geometry input must not have any points that has not be applied with any force.

 

See if this helps.

Permalink Reply by Khizer Ishtiaq on October 1, 2011 at 7:58am

Well i tried flattening the forces input...it dint work

All the points are connected to each other using spring component

And there is no Geometry input

 

I'll attach the file... can you have a look... maybe i am missing something here...

 

Increase the iteration slider to full value first... and then enable the kangaroo component... when you are ready to simulate..since file gets a little heavier as you do so..

Permalink Reply by Khizer Ishtiaq on October 1, 2011 at 8:15am

Maybe its the proximity links that kangaroo is not registering as connections..