algorithmic modeling for Rhino
Sort by:
Discussions | Replies | Latest Activity |
---|---|---|
Karamba to SAp2000I'm using the ggKarambaIFC component, but I do something wrong. I do the output IFC and then I import it into Sap, But it doesn't recognize… Started by Alexia Ch |
3 |
Jan 3, 2018 Reply by Jared Parker |
ggProfileOnCurveHi, Can someone help me with this? ggProfileOnCurve component is orienting my profiles not on the correct plane or upside down (180 degree… Started by Rasmus Sainmaa |
2 |
Oct 13, 2017 Reply by Rasmus Sainmaa |
SAP2000 Load combinationsI wanted to check the deflection at mid point of truss for service load combo i.e. Service combination: 1Dead Load Case+ 1Live Load Case I… Started by Usman Altaf |
0 | Jun 9, 2015 |
IFC Export to REVITJon, thank you for all your support and amazing work! I just installed the latest release of the GGBIM IFC interop tool between Rhino and… Started by Georgios Papadogeorgakis |
1 |
Oct 1, 2014 Reply by Jon Mirtschin |
Autodesk.Revit.Excceptions.InvalidOperationExceptionHi Jon, I get the following error message when using the curved Wall IFC definition which you kindly posted on your blog (attached). How co… Started by Arthur Mamou-Mani |
2 |
Oct 26, 2012 Reply by Jon Mirtschin |
Pre-stress on mesh using StructDrawRhinoDear experts, I'm quite new with Grasshopper so forgive me if my question is obvious. For my bachelor thesis I am trying to build a Gh par… Started by Wouter Brok |
6 |
Apr 23, 2012 Reply by Wouter Brok |
Welcome to
Grasshopper
Added by morteza khorsand 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by morteza khorsand 0 Comments 0 Likes
Added by morteza khorsand 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by