Grasshopper

algorithmic modeling for Rhino

Trim Surface?

Did I manage to do this before?
Some how I can't find a way to Trim a surface or Split it!
It is me or it can not be done?
I hope it can be done without a Solid.

Thanks anyone out there!

Views: 1975

Replies to This Discussion

Permalink Reply by Manuel on December 17, 2009 at 11:20pm
Permalink Reply by Mark on December 18, 2009 at 8:02am
Thank you so much. You have no idea, after a year off GH (and being a beginner anyway), I had basic problems with subcrv and this one. I lost the flow.

Thanks again.

Marco

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service