Grasshopper

algorithmic modeling for Rhino

Tangent Arc between two curves by input of tan-tan-point

Hi everyone,

I am trying to replicate a command i can carry out in rhino but cannot find an equivalent grasshopper component.

Basically, i want to create an arc segment between two tangent curves by input of —

(1) tangent curve 1

(2) tangent curve 2

(3) point on tangent curve.

This can be carried out in Rhino using the arc command - tangent to curves.

Refer attached.

Does anyone have any ideas how this could be carried out in grasshopper?

-possible workaround with components available?

-execution of same rhino command in grasshopper?

Your help would be greatly appreciated.

Thanks,
Clayton.

Views: 6135

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on August 23, 2013 at 2:27am

Hi Clayton,

that function doesn't exist in Grasshopper (yet). There are some tangent circle/arc tools, but not that particular one.

--

David Rutten

david@mcneel.com

Tirol, Austria

Permalink Reply by Pieter Segeren on August 25, 2013 at 5:55am

Hi Clay, I figured from your pdf the two curves you are talking about are in fact lines, and came up with this workaround definition. Can you test it to see if it behaves like you want?

Attachments:
Permalink Reply by Arian Hakimi on June 25, 2018 at 12:56am

Thanks for the def. but in this approach you can't set the center arc point. Is it possible to use the same approach "Tangent Arc 2 lines and pt(Center Arc) ? 

Best,

A

Permalink Reply by aditya.d.bhatt on December 29, 2018 at 7:46am
any chance -there is a gh arc tan tan point workaround yet?
Permalink Reply by aditya.d.bhatt on January 1, 2019 at 10:32am

figured it out : using BiArc and start and end tangents. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service