Grasshopper

algorithmic modeling for Rhino

surface egdes

hi,

anyone knows how to extract the edges of a surface as a curve?

wire only works on breps

thanks,

Peter

Views: 199

Replies to This Discussion

Permalink Reply by Luis Fraguada on September 22, 2010 at 8:32am


Surface is a single faced Brep...both Brep Wires and Brep Edges works fine...as you see they both output 4 curves for a simple surface...then you can join them together.
Permalink Reply by peter on September 22, 2010 at 8:34am
works fine now, thanks
it didn't work before ....
anyway, thanks

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service