Grasshopper

algorithmic modeling for Rhino

Sub-domain problem

I solved a problem thanks to Danny Boyes by using a Shatter the right way but I still have an unsolvable issue with the Subcrv component.

I can't get the zeros out of the way from the Split, no matter what.
The picture shows what I mean by comparing Intervals set manually or via components into the Subcrv

Any possible explanation?
Thank you.

Views: 290

Attachments:

Replies to This Discussion

Permalink Reply by Vicente Soler on December 14, 2009 at 12:44pm
use the Domain component (under scalar->domain) in between the split component and the subcurve component. Connect A with A and B with B.
Permalink Reply by Mark on December 14, 2009 at 12:54pm
Great!
I could not find the "Domain" (is this with the 0.6.0043?, I am using the 0.6.0019) but I used the Interval. Are these the same?
Permalink Reply by Vicente Soler on December 14, 2009 at 1:02pm
It's the same thing, apparently it's been renamed. I'm not sure why, i thought interval was the more correct name for the data type.
Permalink Reply by Mark on December 14, 2009 at 1:07pm
So much to learn....
Thank you

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service