Grasshopper

algorithmic modeling for Rhino

Solid Difference question

Hi,

 

I have a small problem for which i could use some help. I'm trying to construct something like a termite or ant pile. This is build up out of several stacked layers. So for so good.

 

Now i'm trying to subtract the inner layers from the outer layers to create a hollow structure. This is works, but in some cases the layer is completely removed. Ive tested it with a list item from top to bottem and then there issnt any problem.

 

Any suggestions for this problem?

Views: 453

Attachments:

Replies to This Discussion

Permalink Reply by Yoann Mescam (Systemiq) on October 5, 2011 at 10:11am

Graft the 2 inputs of SDiff.

Permalink Reply by Tsooj on October 5, 2011 at 11:33am
Do you mean graft after subtracting the both structures? Then the inner and outer structure would look exactly the same. That is not what i was looking for.
Permalink Reply by Yoann Mescam (Systemiq) on October 5, 2011 at 11:45am

No I mean before:

Permalink Reply by Michael Pryor on October 5, 2011 at 12:00pm

deleted my answer, just realized it wasn't giving them based on data mis match

 

Permalink Reply by Tsooj on October 5, 2011 at 1:16pm
That's it. Didn't even knew that the option existed. Thanks!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service