Grasshopper

algorithmic modeling for Rhino

Simple diamond pattern

Hey guys, I am trying to make an offset diamond pattern from the triangle grid component.

I have attached a mocked up image of what I want to achieve.

If anyone could point me in the right direction that would be great

Cheers, Sam

Views: 1004

Attachments:

Replies to This Discussion

Permalink Reply by pyrit on May 28, 2012 at 9:45am

for a ready made solution, google for lunchbox components

Permalink Reply by Sam Stringleman on May 28, 2012 at 4:24pm

thanks pyrit, I think that might be just what I was looking for

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service