algorithmic modeling for Rhino

I need to cut holes from various strips using the solid difference tool. The Grasshopper string which was previously working has suddenly failed (1. Boolean Difference set is empty) after installing the plug-in RhinoNest. I am wondering if this is an issue of tolerance? (Model units : mm, absolute tolerance 0.01 units) or is there a problem in the code?

Any suggestions?

Views: 390


Replies to This Discussion

i dont think is rhinonest

i have it installed, and your definitions is working ok

i have the same tolerance that you described

im working with version 09.0075

Thanks for your quick response - it was a big with the version of Grasshopper I was working on 09.0075 works again!






  • Add Photos
  • View All

© 2020   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service