Grasshopper

algorithmic modeling for Rhino

Does anyone know why they have changed the surface control points in Rhino 5?

In Rhino 4 surface control points were at the corners of the surface, however, in 5 they are now offset on the outside edge of the surface.

Views: 1655

Replies to This Discussion

Sometimes they are at the corners, sometimes they are beyond the trimmed region. I don't think Rhino5 differs much from Rhino4 in this respect. What matters is how you create the surface. Whether you end up with a trimmed or untrimmed surface.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

What is weird is that i tried this in both 4 and 5 with different results. I created a rectangle and did a planar srf command. In 4 control pts were at the edges but in 5 they were offset.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service