Grasshopper

algorithmic modeling for Rhino

referenced surfaces as breps, loft borders, join into one brep?

hi everyone

 

i have what i feel is a pretty simple problem.

 

i have 2 surfaces i am referencing from rhino as breps. i then extract their wireframes, loft them (separately), and then wish to join the "top", "bottom" (original breps), and their lofted sides into one single brep.

 

this is something which has eluded me.

 

when i do the lofting, and joining, in rhino, and reference it as a brep, there is no problem.

 

so something in my "joining" method is not allowing me to get the desired outcome.

 

i have tried join brep and boolean union, to no avail.

 

any suggestions would be appreciated!

 

thanks!

benjamin

 

(see attached) 

Views: 2560

Attachments:

Replies to This Discussion

Permalink Reply by Pieter Segeren on March 6, 2011 at 3:06pm
Hi Benjamin, flatten your last join component. (and remove the SUnion component). Is this what you wanted?
Permalink Reply by benjamin jenett on March 6, 2011 at 3:49pm

pieter,

 

yes!

 

that worked perfectly! i knew it was simple, but thanks for showing me how!

 

cheers

 

benjamin 

Permalink Reply by James on February 11, 2015 at 11:44am

Thank You Pieter!

(4 years later)

Permalink Reply by Pieter Segeren on February 12, 2015 at 3:12am

:) You're welcome James, thank you for using the site's Search function and putting in some effort!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service