Hi all, I'm taking a n number of centroid points and using an attractor to offset them and then interpolating a curve through the offset centroids, however the order of the points changes when i offset and gives me an undesired result, was wondering if there was a way to fix this issue w/o having to use list item to reorganize the points. Thank you -Boris
it's difficult to tell without seeing the definition - curve offsets change the tree structure, so you need to take that into account when you join paths again. Also, did you check the order when re-connecting? Are you sure that the square on the right side are not then moved "to the left" (it would seem that the order would then be right)?
i seemed to have found the problem, the surfaces where offsetting inversely, offsetting inside the square and then back out again causing this issue. Thank you though for your help, i went back and took a good look at my def. and found the problem.