Grasshopper

algorithmic modeling for Rhino

pipe radius variation, twist problem

Oi,

 

I made this easy thingy, but now i see there are 2 twists in the surface,

I tried rebuilding the curve but that didnt work...

 

Any suggestions?

 

W

 

Views: 466

Replies to This Discussion

Permalink Reply by Pieter Segeren on September 20, 2011 at 9:12am
How about Lofting the circles Woutr? (with align option checked)
Permalink Reply by Woutr on September 20, 2011 at 9:20am
Tnx man !!, that did the trick perfectly :)
(idd, "align" was necessary)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2026   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service