Grasshopper

algorithmic modeling for Rhino

Parametric Truss

Hello

can somebody help me solve this problem.

I would like to apply my GH script on curve nr. 1 and 3 as I did on curve nr. 2. My goal is to apply I. Leonidov's plans for Magnitogorsk (00*.jpg) to the curves drawn in my Rhino file. I am stucking on this problem since a few days and can't find any solution. Can someone help me with some ideas?

Views: 323

Attachments:

Replies to This Discussion

Permalink Reply by Hannes Löschke on March 5, 2012 at 3:27pm

Complex curves like your curves 1 and 3 end up as a set of surfaces when fed to the loft or Surface from curves component. (It says open BRep where is should say Surface)

Try SweepRail components with curves 1 or 3 and their offsest as rail curves to build one Surface. (This will flip U and V for the resulting surface)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service