algorithmic modeling for Rhino
Offset pt grid
I set this up so I could offset a grid to avoid using two surfaces to generate two identical grids. I just can't figure out how to control the move distance of the moved points. I assume I need to set an expression for this but I'm not sure how to set it up. Any suggestions would be greatly appreciated and reading material about expressions in relation to grasshopper. Thanks
Views: 895
Replies to This Discussion
-
Permalink Reply by Hannes Löschke on
-
Z is a vector and probably of length 1. Scale this vector or explicitly set its amplitude to change the translation distance.
-
-
Permalink Reply by Cameron S. Andersen on
-
thank you, I will try that
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Recrusive Split
Added by Parametric House 0 Comments 0 Likes
-
Table Field
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
