Grasshopper

algorithmic modeling for Rhino

Mesh Error

I have been following a tutorial about how to get a voronoi onto a surface - so far so good, but I have hit a problem when it comes to turning this into a mesh - I am greeted with the error 'insufficient vertices for a mesh'. I'm still relatively new to grasshopper, so I am not sure where I am going wrong. Is anyone able to point me in the right direction? I'd be very grateful! Many thanks!

Views: 995

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Michael Pryor on March 15, 2013 at 3:29pm

post the files

Permalink Reply by Tash Tash on March 15, 2013 at 4:02pm

attached now! Do you also need the rhino file? It is a single point - I can make a file if needed. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service