Grasshopper

algorithmic modeling for Rhino

Making Slots for U & V Struts to fit into each other in "Waffle" form

Hey everybody,

 

Attached are my rhino & grasshopper file for an attempt at a waffle pattern based on a brep surface.

 

I'm trying to put points at each intersection of U and V top curves, as well as the intersections of bottom curves. I figure if I can locate where the two axes intersect, I can place a rectangle shape there and make slots for the two pieces to fit together.

 

Please let me know of any better way to do this. I've tried using definitions (such as lift architect's) and haven't had any luck.

 

I tried to use the intersect curve-to-curve component to show the points of intersection, but it only displays one intersection per strut.

 

Please help, thanks!

Views: 999

Attachments:

Replies to This Discussion

Permalink Reply by Eric Mims on October 4, 2011 at 8:26pm
try using flatten on the ccx, see if that does what you want
Permalink Reply by Chris Tietjen on October 4, 2011 at 8:30pm
Chris
Attachments:
Permalink Reply by Sean P. Snyder on October 5, 2011 at 12:23pm

Wow, thanks a lot guys. That was really fast. I'll let ya know how it goes. 

 

Sean

Permalink Reply by Sean P. Snyder on October 5, 2011 at 12:46pm

Yeah, that worked. Would you mind explaining why the flatten option did that? Thanks a lot.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service