Grasshopper

algorithmic modeling for Rhino

making a 30/ 30 grid..

Good Evening :)

so i had some questions regarding dividing  surfaces.

i am trying to divide a 135x600' surface in a 30x30 grid panel...

i was able to get a 33.75x30' grid by using the sub divide command...

i am hoping to have as much 30x30 grid even if that means having smaller/residual pannels on the exterior of the surface...

please help me... 

God Bless :)

Views: 348

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on August 15, 2017 at 10:10pm

Hi.

Some of your curve containers are empty.

Anyway you could do it as the attached def.

Attachments:
Permalink Reply by Mohamed Ibrahim on August 16, 2017 at 2:47am

I am not sure if this consider right, but check it out 

Attachments:
Permalink Reply by Pieter Segeren on August 16, 2017 at 3:39am

How about doing it like this:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service