Grasshopper

algorithmic modeling for Rhino

looking for help to create simple line

hello
i would like to ask anybody for help,

in attached definition, there is a simpe task. create lines from generated points, the trouble is, one set was made by dividing an ark - they are labeled 0 to x and the other is made from intersecting surface and line - labeled all 0. no way to connect them properly. there might have been some ways around it but i cand find any

something like spliting a line by surface. or change the labeling of points. i am sure that would be easy if i know vb script, but unfortunately i dont.

so please, anybody. i am running in this kind of a problem third time last week

Views: 359

Attachments:

Replies to This Discussion

Permalink Reply by Luis Fraguada on June 22, 2009 at 10:51am
You see that the line component is taking in the A Input a tree and in the B a list. Without looking too deep into your vast definition, try flattening the input on the line A Input...
Permalink Reply by Ondrej Strejcek on June 22, 2009 at 11:13am
flattening... how can i do that?
Permalink Reply by Luis Fraguada on June 22, 2009 at 11:48am
Right click on the A input on the line component, you will see "Flatten" ... turn this option on by selecting it.
Permalink Reply by Ondrej Strejcek on June 22, 2009 at 12:46pm
thank you so much, it so simple i culdnt find it,

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service