Grasshopper

algorithmic modeling for Rhino

Loft in GH 0.90006

Before I was able to loft two surfaces with GH, which isn't possible in Rhino alone. In 0.90006 I find sometimes it works, and sometimes it says "Couldn't convert surface to curve".

Views: 362

Replies to This Discussion

Permalink Reply by Michael Pryor on August 31, 2012 at 9:27am

IT works same as it did before(number 1). The surface cannot have holes (number 2) or you will get that error. A way around would be option number 3.

Permalink Reply by Javier Vizoso on August 31, 2012 at 9:58am

Ah yes, mine was edge case #2. Thanks.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service