algorithmic modeling for Rhino
Loft
I am trying to loft those two curves.
I would like to make a surface around that simple sphere to create a single surface.
My idea was to create windows around a surface.
Could you possibly help me ?
Thank you.
Marc
Views: 258
- Attachments:
-
-
Untitled-2.jpg, 271 KB -
Untitled-1.jpg, 275 KB
-
China-museet.gh, 50 KB
-
Replies to This Discussion
-
Permalink Reply by Hannes Löschke on
-
Sweep2 probably is the better component for this task. Or you could rebuild the curves to the same amount of CPs.
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Grab Building
Added by Parametric House 0 Comments 0 Likes
-
Kangaroo Mesh
Added by Parametric House 0 Comments 0 Likes
-
Wind Pavilion
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
