internalised data gets lost when copying from one file to another

Replies to This Discussion

Permalink Reply by LLXXZZ on May 19, 2014 at 6:03pm

me too, why? i do not known.

Permalink Reply by Tudor Cosmatu on May 20, 2014 at 1:17am

happened to me as well...

Permalink Reply by David Rutten on May 20, 2014 at 3:02am

Copy-paste in the same file works fine? Saving and opening works fine?

Are you copy-pasting between different GH files in the same Rhino session, or across Rhino sessions?

--

David Rutten

david@mcneel.com

Permalink Reply by Andrei Raducanu on May 21, 2014 at 2:13am

Hi, David! Unfortunately i can't remember what i was working on back then and exactly how it was actig, but i tried it now (on another computer 'though, with build 0.9.0075), and it acts like this: 
- copy-paste in the same file works fine

- closing and opening the file (while gh keeps running) still works fine

- closing and opening the file (while unloading GH but not closing Rhino) still works fine

- pasting the component in GH in a parallel Rhino instance doesn't work (says null)

- opening the file in a parallel Rhino instance doesn't work (says null)

- closing all Rhino sessions and reopening the GH file doesn't work (says null)
Hope this helps, thanks for the support!
I attached the file in case it helps (it's the highest component on the canvas).

Attachments:

• KERFING.gh, 9 KB

Permalink Reply by User on July 7, 2014 at 2:19am

Hi, I have the same problem. When I reopen the file, I don't have the geometry, but the BREP is not empty!

any suggestion?

Permalink Reply by David Rutten on July 7, 2014 at 3:33am

How were the breps made in the first place? Through Grasshopper logic or were they imported from the 3DM file? I really need to replicate this problem to get any further trying to solve it.

Anything you can upload in order to reproduce would be most welcome.

--

David Rutten

david@mcneel.com

Permalink Reply by Mateusz Zwierzycki on July 7, 2014 at 7:26am

I have the same problem quite often. Usually happens when someone sends me 3dm file with geometry and gh file operating on it. When I open the rhino file first and grasshopper later, I have to set the geometry back to gh manually. (the same happens when I open gh first and then rhino file).

PS. The rhino geometry is made manually within rhino.

Permalink Reply by User on July 29, 2014 at 3:52pm

Hi, Finally I found a geometry with this error. Probably you can open this file and see a brep, but if you copy and paste in another definition you loose it.

Attachments:

• Test Brep.gh, 1 KB