Grasshopper

algorithmic modeling for Rhino

Inflated Mesh offset

I've been working with an inflated mesh definition where a voronoi definition determines the size and shape of the hanging mesh. I've offset and fillet the voronoi grid, but can't figure out how to make a surface between the offset lines of the voronoi. Pretty much to make a path between these half bubbles.

(I plan on animating the grid moving voronoi that's the reason for the curves and animation def. in grasshopper)

Views: 2751

Attachments:

Replies to This Discussion

Permalink Reply by taz on December 2, 2011 at 11:35am

It's not the most straightforward way but you can create BReps from your voronoi openings and use them as punch outs for a surface with [Trim Solid].

Permalink Reply by m.english on December 2, 2011 at 12:31pm

Thanks for the help. I found it easier just to make a boundary surface and flatten both curve sets. If anyone is trying to use this definition, its important to realize that the offset is a negative number.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service